2.2. Host System Requirements

2.2.1. Hardware

The LFS editors recommend that the system CPU have at least four cores and that the system have at least 8 GB of memory. Older systems that do not meet these requirements will still work, but the time to build packages will be significantly longer than documented.

2.2.2. Software

Your host system should have the following software with the minimum versions indicated. This should not be an issue for most modern Linux distributions. Also note that many distributions will place software headers into separate packages, often in the form of <package-name>-devel or <package-name>-dev. Be sure to install those if your distribution provides them.

Earlier versions of the listed software packages may work, but have not been tested.

  • Bash-3.2 (/bin/sh should be a symbolic or hard link to bash)

  • Binutils-2.38 (Versions greater than 2.43.1 are not recommended as they have not been tested)

  • Bison-2.7 (/usr/bin/yacc should be a link to bison or a small script that executes bison)

  • Coreutils-8.1

  • Diffutils-2.8.1

  • Findutils-4.2.31

  • Gawk-4.0.1 (/usr/bin/awk should be a link to gawk)

  • GCC-12.2 including the C++ compiler, g++ (Versions greater than 14.2.0 are not recommended as they have not been tested). C and C++ standard libraries (with headers) must also be present so the C++ compiler can build hosted programs

  • Grep-2.5.1a

  • Gzip-1.3.12

  • Linux Kernel-5.19

    The reason for the kernel version requirement is that we specify that version when building glibc in Chapter 5 and Chapter 8, and 5.19 is the oldest kernel release supported by Glibc for LoongArch.

    [Important]

    Important

    If a Linux distribution on LoongArch provides a kernel older than 5.19, it indicates the distribution is using a preliminary version of the kernel ABI. The preliminary draft was rejected by the kernel maintainers and it's fundamentally incompatible with the packages we will built for LFS. Such old-world distributions (for example, Loongnix) cannot be used as a host distro for building LFS.

    Do not attempt to update the kernel to 5.19 or later on a old-world distro because doing so will cause a boot failure. Use a new-world distribution providing Linux Kernel 5.19 or newer instead. You may need to contact the vendor of your hardware to get a firmware update for booting a new-world distribution because the boot protocol of LoongArch is stabilized after the launch of the early LoongArch hardwares.

    We require the host kernel to support UNIX 98 pseudo terminal (PTY). It should be enabled on all desktop or server distros shipping Linux 5.19 or a newer kernel. If you are building a custom host kernel, ensure CONFIG_UNIX98_PTYS is set to y in the kernel configuration.

  • M4-1.4.10

  • Make-4.0

  • Patch-2.5.4

  • Perl-5.8.8

  • Python-3.4

  • Sed-4.1.5

  • Tar-1.22

  • Texinfo-5.0

  • Xz-5.0.0

[Important]

Important

Note that the symlinks mentioned above are required to build an LFS system using the instructions contained within this book. Symlinks that point to other software (such as dash, mawk, etc.) may work, but are not tested or supported by the LFS development team, and may require either deviation from the instructions or additional patches to some packages.

To see whether your host system has all the appropriate versions, and the ability to compile programs, run the following commands:

cat > version-check.sh << "EOF"
#!/bin/bash
# A script to list version numbers of critical development tools

# If you have tools installed in other directories, adjust PATH here AND
# in ~lfs/.bashrc (section 4.4) as well.

LC_ALL=C 
PATH=/usr/bin:/bin

bail() { echo "FATAL: $1"; exit 1; }
grep --version > /dev/null 2> /dev/null || bail "grep does not work"
sed '' /dev/null || bail "sed does not work"
sort   /dev/null || bail "sort does not work"

ver_check()
{
   if ! type -p $2 &>/dev/null
   then 
     echo "ERROR: Cannot find $2 ($1)"; return 1; 
   fi
   v=$($2 --version 2>&1 | grep -E -o '[0-9]+\.[0-9\.]+[a-z]*' | head -n1)
   if printf '%s\n' $3 $v | sort --version-sort --check &>/dev/null
   then 
     printf "OK:    %-9s %-6s >= $3\n" "$1" "$v"; return 0;
   else 
     printf "ERROR: %-9s is TOO OLD ($3 or later required)\n" "$1"; 
     return 1; 
   fi
}

ver_kernel()
{
   kver=$(uname -r | grep -E -o '^[0-9\.]+')
   if printf '%s\n' $1 $kver | sort --version-sort --check &>/dev/null
   then 
     printf "OK:    Linux Kernel $kver >= $1\n"; return 0;
   else 
     printf "ERROR: Linux Kernel ($kver) is TOO OLD ($1 or later required)\n" "$kver"; 
     return 1; 
   fi
}

# Coreutils first because --version-sort needs Coreutils >= 7.0
ver_check Coreutils      sort     8.1 || bail "Coreutils too old, stop"
ver_check Bash           bash     3.2
ver_check Binutils       ld       2.38
ver_check Bison          bison    2.7
ver_check Diffutils      diff     2.8.1
ver_check Findutils      find     4.2.31
ver_check Gawk           gawk     4.0.1
ver_check GCC            gcc      12.2
ver_check "GCC (C++)"    g++      12.2
ver_check Grep           grep     2.5.1a
ver_check Gzip           gzip     1.3.12
ver_check M4             m4       1.4.10
ver_check Make           make     4.0
ver_check Patch          patch    2.5.4
ver_check Perl           perl     5.8.8
ver_check Python         python3  3.4
ver_check Sed            sed      4.1.5
ver_check Tar            tar      1.22
ver_check Texinfo        texi2any 5.0
ver_check Xz             xz       5.0.0
ver_kernel 5.19

if mount | grep -q 'devpts on /dev/pts' && [ -e /dev/ptmx ]
then echo "OK:    Linux Kernel supports UNIX 98 PTY";
else echo "ERROR: Linux Kernel does NOT support UNIX 98 PTY"; fi

alias_check() {
   if $1 --version 2>&1 | grep -qi $2
   then printf "OK:    %-4s is $2\n" "$1";
   else printf "ERROR: %-4s is NOT $2\n" "$1"; fi
}
echo "Aliases:"
alias_check awk GNU
alias_check yacc Bison
alias_check sh Bash

echo "Compiler check:"
if printf "int main(){}" | g++ -x c++ -
then echo "OK:    g++ works";
else echo "ERROR: g++ does NOT work"; fi
rm -f a.out

if [ "$(nproc)" = "" ]; then
   echo "ERROR: nproc is not available or it produces empty output"
else
   echo "OK: nproc reports $(nproc) logical cores are available"
fi
EOF

bash version-check.sh