Beyond Linux® From Scratch - Version 6.3

Chapter 11. System Utilities

Hdparm-7.7

Introduction to Hdparm

The hdparm package contains a utility that is useful for controlling ATA/IDE controllers and hard drives both to increase performance and sometimes to increase stability.

[Warning]

Warning

As well as being useful, incorrect usage of hdparm can destroy your information and in rare cases, drives. Use with caution and make sure you know what you are doing. If in doubt, it is recommended that you leave the default kernel parameters alone.

Package Information

User Notes: http://wiki.linuxfromscratch.org/blfs/wiki/hdparm

Installation of Hdparm

Build hdparm by running the following command: 

make

This package does not come with a test suite.

Now, as the root user: 

make install

Note that by default, hdparm is installed in /sbin as some systems may require it during the boot process before /usr is mounted. If you wish to install hdparm under the /usr hierarchy, then replace the above command with the following: 

make binprefix=/usr/ install

Contents

Installed Program: hdparm
Installed Libraries: None
Installed Directories: None

Short Descriptions

hdparm

provides a command-line interface to various hard disk ioctls supported by the stock Linux ATA/IDE device driver subsystem.

Last updated on 2007-08-13 18:57:32 -0500