ac3dec
|
is a free AC-3 stream decoder.
|
extract_ac3
|
will take an MPEG-2 stream and produce AC-3 audio to
stdout if it exists.
|
as10k1
|
is an assembler for the emu10k1 DSP chip present in the
Creative SB Live, PCI 512, and emu APS sound cards. It is
used to make audio effects such as a flanger, chorus or
reverb.
|
echomixer
|
is the Linux equivalent of the Echoaudio console
application from Echoaudio. It is a tool to control all
the features of any Echoaudio soundcard. This includes
clock sources, input and output gains, mixers, etc.
|
envy24control
|
is a control tool for Envy24 (ice1712) based sound cards.
|
hdspconf
|
is a GUI to control the Hammerfall HDSP Alsa Settings. Up
to four hdsp cards are supported.
|
hdsploader
|
is used to load the firmware required by the Hammerfall
HDSP sound cards.
|
hdspmixer
|
is the Linux equivalent of the Totalmix application from
RME. It is a tool to control the advanced routing
features of the RME Hammerfall DSP soundcard series.
|
ld10k1
|
is the server of a EMU10K[1,2] patch loader for ALSA.
|
lo10k1
|
is the client of a EMU10K[1,2] patch loader for ALSA.
|
qlo10k1
|
is a Qt GUI for the
ld10k1
patch loader.
|
mixartloader
|
is a helper program to load the firmware binaries onto
the Digigram's miXart board sound drivers. The following
modules require this program: snd-mixart. These drivers
don't work properly at all until the certain firmwares
are loaded, i.e. no PCM nor mixer devices will appear.
|
pcxhrloader
|
is a helper program to load the firmware binaries onto
Digigram's pcxhr compatible board sound drivers. The
following modules require this program: snd-pcxhr. These
drivers don't work properly at all until the certain
firmwares are loaded, i.e. no PCM nor mixer devices will
appear.
|
rmedigicontrol
|
is a control tool for RME Digi32 and RME Digi96 sound
cards. It provides a graphical frontend for all the sound
card controls and switches.
|
cspctl
|
is an SB16/AWE32 Creative Signal Processor (ASP/CSP)
control program.
|
sbiload
|
is an OPL2/3 FM instrument loader for the ALSA sequencer.
|
sscape_ctl
|
is an ALSA SoundScape control utility.
|
us428control
|
is a Tascam US-428 control program.
|
usx2yloader
|
is a helper program to load the 2nd Phase firmware
binaries onto the Tascam USX2Y USB sound cards. It has
proven to work so far for the US122, US224 and US428. The
snd-usb-usx2y module requires this program.
|
vxloader
|
is a helper program to load the firmware binaries onto
the Digigram's VX-board sound drivers. The following
modules require this program: snd-vx222, snd-vxpocket,
snd-vxp440. These drivers don't work properly at all
until the certain firmwares are loaded, i.e. no PCM nor
mixer devices will appear.
|