LiveCD rebuild help requested
r.young at irl.cri.nz
Mon Jun 11 03:53:02 PDT 2007
Yes, I observed the same artifact after shutting down X.
It is not too much of a iritation. What would you suggest as
an alternative to "nv" (apart from the proprietary nvidia drivers)?
On Mon, 11 Jun 2007 00:26:29 -0700
lists <lists at jaqui-greenlees.net> wrote:
> Alexander E. Patrakov wrote:
> > All chipset-specific video drivers, except "nv", contain a full list of
> > supported PCI IDs. The "nv" driver contains only a partial list, and in fact
> > supports more than it advertises. In this case, the words "Unknown NVIDIA
> > chip" appear in the log. Does this apply to your card?
> The nv driver for x leaves artifacts if you shut the xserver down, with
> my nvidia chipset card.
> The nvidia proprietary driver resolves the issue.
> The card is actually branded Asus, it uses the nvidia tc 6800 chipset.
> I know that including the proprietary drivers is not going to happen, I
> just figure that getting it known that the nv driver may not be the best
> option for an nvidia chipset is a good idea.
> The artifact is the mouse cursor in the lower right quadrant of the
> display. This persists in both a no x environment after shutting x down,
> as well as coming back from power save screen blanking or screensaver.
> FAQ: http://www.linuxfromscratch.org/faq/
> Unsubscribe: See the above information page
> This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.
This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.
More information about the livecd