Interface eth0 does not exist
simone.dalmasso at gmail.com
Mon Nov 2 10:18:29 PST 2009
Thanks a lot, Michael, for your suggestions. :-)
Now I'm going to build a 6.5 version. Surely I will need your help again.
2009/11/2 Michael L. <lfs-support at cosis.dk>
> Hi Simone,
> In that case (If you only have a sit0 and the lo interfaces) your kernel
> doesn't have the correct driver for the VMWare Nic compiled into it.
> Going to LFS-6.5 is a good choice - but you still need to compile the
> right NIC driver into the kernel before you can use networking :-)
> Optionaly select all the Netvorking Drivers, but build them as modules -
> that way you can reboot, and use "lsmod" to see which module is used for
> your NIC - and then compile the kernel again using the driver that was
> used when you were using modules.
> Best Regards
> Simone Dalmasso wrote:
> > I have a sit0:<NOARP> ....
> > Under the udev folder I don't have the 70-persistent-net.rules file
> > even if I have launched "/lib/udev/write_net_rules all_interfaces".
> > Maybe I should follow the suggestion of William, in that way I'll have
> > the system updated.
> > Simone
> > 2009/11/2 Michael L. <lfs-support at cosis.dk <mailto:lfs-support at cosis.dk
> > Hi Simone,
> > If you try a "ip link" - do you get anything else other than:
> > 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
> > link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
> > If you do, and it contains a ethX adaptor, you need to edit the
> > following file:
> > /etc/udev/rules.d/70-persistent-net.rules
> > Delete any entries which contains ethX interfaces.
> > Then reboot - and the system should configure you nic as eth0.
> > Best Regards
> > Michael
> > Simone Dalmasso wrote:
> > > Hi list I've finally built my LFS and it works. Just one issue,
> > while
> > > booting I get a Warn: "Interface eth0 doesn't exist" and when
> > shutting
> > > down I also get "Device eth0 doesn' exist"
> > > I tried to recompile the kernel doing a make clean and then
> > activating
> > > the network driver for AMD Pcnet32 (got with lspci from LiveCd) in
> > > the kernel gui.
> > > But nothing changes. I'm working under a virtual machine (VMWare
> > Fusion).
> > > Can you help me? Thanks.
> > >
> > > Simone
> > >
> > >
> > --
> > http://linuxfromscratch.org/mailman/listinfo/lfs-support
> > FAQ: http://www.linuxfromscratch.org/lfs/faq.html
> > Unsubscribe: See the above information page
> FAQ: http://www.linuxfromscratch.org/lfs/faq.html
> Unsubscribe: See the above information page
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the lfs-support