LFS 6.3 Chapter 6.12, GCC-4.1.2 startfiles check fails --> no output

Pixel 73 pixel73 at hotmail.com
Thu Dec 17 06:58:55 PST 2009




----------------------------------------
> Date: Wed, 16 Dec 2009 12:06:23 -0500
> Subject: Re: LFS 6.3 Chapter 6.12, GCC-4.1.2 startfiles check fails --> no output
> From: linuxscratch at gmail.com
> To: lfs-support at linuxfromscratch.org
>
> On 12/16/09, stosss wrote:
>>>> On 12/15/09, Pixel 73 wrote:
>>> Thank you very much for your help. What can I do, if I already did 'make
>>> install'? How can I uninstall again?
>
> In linux, attempted uninstall risks more harm than good unless you
> really know what might break which is usually not the case.
>
> At 6.12, GCC-4.1.2, the "Readjusting the toolchain" step has already
> been done, so only a super-geek has any chance to go to anything
> before that without starting at the beginning.
>
> Something has gone wrong and it is possible that the resulting system
> will be flawed. On the other hand, it is possible that you missed
> something in the GCC-4.1.2 step. As an exercise, it may be possible to
> remove the unpacked GCC-4.1.2 sources dir and the gcc-build dir and do
> that step again. This time paying close attention to the 'make" and
> 'make -k check' and perhaps logging the output for close examination
> like:
> make 2>&1 | tee my_log1
> make -k check 2>&1 | tee my_log2
>
> If you get the same failure again, then it would be best to start over
> from the beginning which you might be advised to do anyway.
> --
> http://linuxfromscratch.org/mailman/listinfo/lfs-support
> FAQ: http://www.linuxfromscratch.org/lfs/faq.html
> Unsubscribe: See the above information page
 
 
Thank you very much for your help.
After make distclean I deleted gcc-4.1.2 and gcc-build again and then extracted and compiled again with your logging-options. There were no exeptional errors occuring.
 
But now I found out, that the startfiles show up when I am entering the following command:
 
grep -o '/lib.*/crt[1in].*succeeded' dummy.log
 
but not when I enter the command as written in the book:
 
grep -o '/usr/lib.*/crt[1in].*succeeded' dummy.log
 
So I think, that the startfiles are in the wrong directory (/lib instead of /usr/lib). Is there a possibilty to correct this or do I have to start over again.
 


  		 	   		  
_________________________________________________________________
Weihnachts-Shopping online: auf Nummer sicher gehen und mit dem MSN Internet Explorer 8 sicher surfen, jetzt kostenlos herunterladen!
http://www.microsoft.ch/msnie8/de


More information about the lfs-support mailing list