Sundance ethernet card doesn't update carrier properties
stout at lost-soul.net
Sat Oct 14 22:06:17 PDT 2006
blah blah blah, yackity smackity, blah blah blah.... ifconfig should never
have been tossed away. If a connection was down (no carrier), it wasn't
listed in output, easy to parse.
Of course, it didn't exactly act that way with aliases, but thats special
case (tho technically, it never did list eth1:1 when it was brought down
On Sat, 14 Oct 2006, Dan Nicholson wrote:
> I was working on adding a fix to the BLFS network setup scripts so
> that they will be skipped if the network card isn't connected. The
> original sender suggested using `/sbin/ip link show <interface> | grep
> NO-CARRIER'. Later I found that this info is exported through sysfs
> since ~2.6.10 in /sys/class/net/<interface>/carrier. See the details
> The problem is, I can't in good faith add the fix because one of my
> ethernet cards doesn't do what I say it's going to do. The first
> problem is that under normal circumstances, unplugging the cable
> neither makes /sys/.../carrier switch to 0 nor does NO-CARRIER show up
> in the output from /sbin/ip. It always shows an active carrier.
> If I boot with the cable unplugged, /sbin/ip still always shows an
> active carrier. /sys/.../carrier does something stranger where if I
> cat the value early, I think it's just a null character because the
> cat comes back with an "Invalid argument" error. However, it briefly
> changes to 1 (I check the value again during the network init script),
> then changes back to the null character later.
> This leads me to believe that it's an issue with the kernel driver for
> my device. Here's what lspci has to say about my device:
> 00:0f.0 Ethernet controller: D-Link System Inc DL10050 Sundance
> Ethernet (rev 12)
> Subsystem: D-Link System Inc DFE-550TX
> Flags: bus master, medium devsel, latency 80, IRQ 10
> I/O ports at 1000 [size=128]
> Memory at e000a400 (32-bit, non-prefetchable) [size=512]
> [virtual] Expansion ROM at 30000000 [disabled] [size=64K]
> Capabilities:  Power Management version 2
> dmesg says nothing unusual:
> sundance.c:v1.2 11-Sep-2006 Written by Donald Becker
> eth0: D-Link DFE-550TX FAST Ethernet Adapter at 00011000,
> 00:05:5d:e5:ae:08, IRQ 10.
> eth0: MII PHY found at address 1, status 0x782d advertising 01e1.
> eth0: MII PHY found at address 0, status 0x782d advertising 01e1.
> I'm running linux-2.6.19-rc2 to test right now, and I have the
> sundance driver loaded as a module. I also tested on 2.6.18 and
> 22.214.171.124, and the behavior was the same.
> My question is, are there any kernel heroes here who'd like to help me
> debug this? I can't point around in the kernel source how I think
> things chain up, but I'm just kind of guessing. Otherwise, I guess
> I'll take this over to LKML.
> FAQ: http://www.linuxfromscratch.org/lfs/faq.html
> Unsubscribe: See the above information page
More information about the lfs-support