Network Issues

Gerard Beekmans gerard at linuxfromscratch.org
Sun Sep 23 16:23:35 PDT 2001


On Sun, Sep 23, 2001 at 11:29:44PM +0100, Timothy Greaves wrote:
> In LFS it looks like:
> 
> eth0      Link encap:Ethernet  HWaddr 00:00:4B:19:34:D7  
>           inet addr:192.168.1.2  Bcast:192.168.1.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:3 dropped:0 overruns:0 carrier:0

I don't quite like the errors there. I'm know what the errors value
means though.

Are you able to ping 127.0.0.1 by the way?

Have a look at the /proc/pci file (i assume it's a pci card) on both Redhat
an LFS and see if they are using the same resources (IO and IRQ addresses).

Also the RX and TX above are set to 0. So it seems the data isn't even
leaving the network card. This could mean a route problem.

Run "route" on both Redhat and LFS and compare again. they should be the
same (though changes aren't always bad, it depends on the change, so
how about you forward the outputs to us again so we can have a look at
those as well).

-- 
Gerard Beekmans
www.linuxfromscratch.org

-*- If Linux doesn't have the solution, you have the wrong problem -*-
-- 
Unsubscribe: send email to listar at linuxfromscratch.org
and put 'unsubscribe lfs-support' in the subject header of the message



More information about the lfs-support mailing list