[blfs-support] fatal error: goo/gmem.h: No such file or, directory; but file does exist!!; cups-filters

Leon Goldman leon244 at comcast.net
Mon Nov 5 11:16:23 PST 2012


Just a follow up. I did create and get running cups 1.6.1. I can add a 
printer, but can't get it to work. I also lost the ability to start cups 
via "service -f cups" command. All things to pursue over time. Thanks
Leon
On 11/05/2012 12:37 PM, Leon Goldman wrote:
> Thank you all. It would appear that I am too far in over my head and I
> should quit while I am ahead. Only next choice seems to be to reinstall
> the OS and leave well enough alone. For now I will leave it as broken as
> it is an hope I don't make it worse.
> Leon
> On 11/05/2012 11:37 AM, Ken Moffat wrote:
>> On Mon, Nov 05, 2012 at 09:39:10AM -0600, Bruce Dubbs wrote:
>>> Leon Goldman wrote:
>>>> Actually /usr/lib/pkgconfig/poppler.pc does exist. However, I am using a
>>>> x86_64 system and have a /usr/lib64/pkgconfig also. When I built poppler
>>>> and libqpdf I just used teh defaults. In /usr/lib64/pkgconfig there is a
>>>> poppler.pc file which lists the version as 0.16. The poppler.pc in
>>>> /usr/lib lists the version as 0.20.5.   Should I uninstall and recompile
>>>> poppler and libqpdf with LIBDIR=/usr/lib64?
>>>>
>>>> Would the correct steps be to first do a make uninstall for poppler and
>>>> libqpf, then remove the directories created when the tarball was
>>>> extracted, re-extract the archive, then proceed with ./configure
>>>> --LIBDIR=/usr/lib64  and then try to recompile cups-filters?
>>> In LFS we said do do 'ln -sv lib /lib64 && ln -sv lib /usr/lib64'
>>>
>>> All of LFS and BLFS assumes that.  The only reason to have separate lib
>>> directories is for the case when you have a 32-bit binary program that
>>> you can't build with 64-bit system.
>>>
>>> See the discussion 'iii. LFS Target Architectures' in LFS.
>>>
>>    Ah, the 'joys' of multilib.
>>
>>    First, I cannot recommend that you ever run 'make uninstall' : that
>> is hardly ever tested - in most cases it will work fine.  But if it
>> doesn't, your system might be broken.
>>
>>    As Bruce says, we don't support multilib in the book.  If your
>> existing system is multilib, you might want to look at cross-lfs
>> (specifically cblfs - from memory, almost everything is built as
>> both 32-bit and 64-bit).
>>
>>    For sorting out what you have done : everything in lib64 should be
>> 64-bit (use file to check the binaries), everything in lib on
>> multilib should be 32-bit.  You haven't specified -m64 or -m32 on
>> what you've done, so looking at the programs you compiled should tell
>> you if your gcc defaults to 32-bit or 64-bit : I would expect 32-bit
>> but knowing is better than assuming.
>>
>>    If you are building as 64-bit, use
>> PKG_CONFIG_PATH=/usr/lib64/pkgconfigfile as well as LIBDIR, and
>> forcing -m64 if you need to.
>>
>>    If you build as 32-bit on that system, and 64-bit turns out to be
>> its default, use -m32 as well as .usr/lib.
>>
>> ĸen




More information about the blfs-support mailing list