Intel 1000MT Lan connection upgrade
tijnema at gmail.com
Wed Feb 21 10:46:08 PST 2007
I didn't tell, but i already solved this problem, i forgot to compile Tulp
into the kernel...
On 2/21/07, Joris Piepers <joris.piepers at gmail.com> wrote:
> Hello Tijnema,
> Be sure you checked all dependencies about your module in the kernel in
> the first place, before you do anything. Once you do a make modules_install
> after the make command (once you compiled the kernel) it should work
> already. Just make sure you copy your System.map and the new kernel to the
> proper location. (in most cases it is /boot)
> Off course you need to reboot your system first to apply the changes and
> after that do a modprobe once it comes back up again. This is just fine once
> you rebooted. It will assure you, the module is properly inserted and that
> it compiled and loads all dependencies ok. That's why most people prefer
> Modprobe instead of insmod. Insmod requires in most cases some more
> knowledge about the dependencies. Now it is just a matter of adding the
> procedures into the boot script so that it will load each time you start
> your system. Tha's all.
> On 2/4/07, Tijnema ! <tijnema at gmail.com> wrote:
> > Hi
> > i upgraded my Realtek RTL8139D(10/100) to a Intel 1000MT (10/100/1000),
> > but i can't get it to work.
> > what i already did, i installed the e1000-7.3.20 kernel module and
> > installed it with insmod.
> > but what do i need to do more?, i placed it in the same PCI slot as my
> > Realtek.
> > Thanks in advance,
> > Tijnema
> > --
> > http://linuxfromscratch.org/mailman/listinfo/blfs-support
> > FAQ: http://www.linuxfromscratch.org/blfs/faq.html
> > Unsubscribe: See the above information page
> FAQ: http://www.linuxfromscratch.org/blfs/faq.html
> Unsubscribe: See the above information page
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the blfs-support