X Consumes constant 90-99% CPU usage

Simon Geard delgarde at ihug.co.nz
Mon Nov 20 01:36:23 PST 2000


On Monday 20 November 2000 10:02, you wrote:
>
> I just downloaded and installed XFree86 4.01 from sources. However, X is
> very slow. Since I have a Athlon 600, 128 MB, and a Matrox Millenium G400
> 32Mb, I decided it couldnt be slow hardware, and I ran 'top'. 'top' shows X
> as using a constant 90-99% CPU usage. Even if I replace my window manager
> by twm, X still uses 90-99% CPU, so its not my window manager. When I boot
> into my Mandrake distro instead of LFS on the same system and run X from my
> Mandrake distro, it runs fine. So I guess its not faulty hardware either. I
> recompiled twice to see if something went wrong there, and even went
> through the trouble of downloading and installing the precompiled binarys
> from xfree86.org, but even that did not solve my problem. Only if I switch
> from X to a virtual console using ALT-Fxx, does the cpu usage of X drop
> down again to (almost) zero. And then as soon as I switch back to my X
> session, it goes all the way back up again and stays there. I am running
> the mga driver that comes with XFree86 401 and not the driver that Matrox
> supplies themselves for X.

I'm using 4.0.1 with a G200, no problems. I'm using the xserver from the DRI 
cvs tree, but apart from that, it's standard. I still don't have 3d working 
quite right, so I'm thinking of going to a standard 4.0.1 source. If I have 
problems with that, I'll let you know...

Simon.


-- 
Unsubscribe: send email to lfs-apps-request at linuxfromscratch.org
and put unsubscribe in the subject header of the message




More information about the blfs-support mailing list